A mark that is not there in daylight
This cartridge carries no visible colourant. The code is applied like any other TIJ print, dries like any other TIJ print, and is invisible under ordinary light. It only appears under a 365 nm ultraviolet source — which makes it a marking tool for authentication and traceability rather than for reading.
Two different jobs, one word
A UV-curable ink hardens under ultraviolet light and stays visible. A covert UV ink is not cured by that light at all — it is read under it. They are separate products, and confusing the two is the most common mistake in this category.
- Invisible in daylight, read at 365 nm
- Runs on the standard HP45-format TIJ body
- For authentication, traceability and warranty control
Where a covert mark earns its place
A mark a customer cannot copy by eye
Nothing is visible in daylight, so the packing looks unmarked to anyone handling it. Verification is deliberate rather than incidental — which is the point of a covert mark.
Traceability without changing the artwork
The visible pack carries no extra print. Batch, serial or lot information can sit in the covert layer while the retail face stays exactly as designed.
Warranty and returns control
A supplier or service centre can confirm whether a unit is genuinely yours without adding a visible authentication mark that a counterfeiter would simply imitate.
Runs on the platform you already have
Same HP45-format body and 42 ml fill as the visible-ink cartridges. If your line already runs TIJ, no new hardware category is involved.
The failure mode to plan around
A covert mark does not fail by being invisible. It fails by being unreadable where someone tries to read it. The mark is deliberately faint, and a substrate that fluoresces under UV — plenty of papers, boards and coatings do — can drown it.
That is why the lamp matters as much as the ink. A 365 nm source is what the mark is built for; a generic blacklight torch at an unspecified wavelength is not. And the reading has to be judged against the substrate's own glow, not against the mark in isolation.
The other failure is organisational. If nobody has agreed who checks, with which lamp, and what result counts as a pass, the mark cannot do its job — however well it prints.
Cartridge data
| Parameter | Value |
|---|---|
| Platform | HP45-format thermal inkjet (TIJ 2.5), one-piece cartridge |
| Ink system | Covert UV — no visible colourant under daylight |
| Nominal capacity | 42 ml industrial fill |
| Print width | 12.7 mm (half-inch) or 25.4 mm (one-inch), depending on model |
| Readout | 365 nm UV source required |
| Chip | Open, non-encrypted — no authentication handshake, no single-use lock-out |
| Operating environment | 15–35 °C, 35–80% relative humidity, non-condensing |
What is worth testing, and in what order
- 1. Read the mark under a 365 nm lamp on the real substrate, not on white paper. Many papers, boards and coatings fluoresce strongly and will swamp a weak mark.
- 2. Check the mark after the handling the pack receives — a rub, a wipe with the ethanol or IPA your cleaning routine uses, a chill cabinet, a shrink tunnel.
- 3. Confirm the reading in the lighting the check will actually happen in. A dark room flatters a covert mark; a lit warehouse does not.
- 4. Agree who verifies, with what lamp, and what counts as a pass — before the run, not after.
A printed coupon under a lab lamp tells you the ink works. A mark that survives your handling, read under the lamp your customer owns, tells you whether the project works. Those are different questions, and only the second one is worth ordering against.
Get Started
READY TO SCALE
YOUR PRINT OPERATION?
Send us your printer model and monthly volume. We'll respond within 24 hours with pricing, spec sheets, and sample availability.